ISO QMS Certified
"Our Science ... Your Success"

Bonding PTFE with Industrial Adhesive

PTFE bonding

PTFE adhesive – Bonding PTFE with Industrial Adhesive

PTFE, commonly known by the trade name Teflon or by the techies amongst us “Polytetrafluoroethylene” is a notoriously difficult material to bond as it is “Non-Stick” by nature. The most common application would be that of non-stick frying pan coating. Consequently when someone calls the helpline asking for a PTFE adhesive, the technical advisor’s shoulders will slump in despair and some serious head scratching will commence. Things are improving nowadays thanks to recent adhesive developments – primers are now available and even structural acrylic adhesives which can be used straight on this beastly surface!

Because of its high temperature resistance and excellent resistance against harsh chemicals, PTFE is often used for extremely challenging applications. So not only do we have a non-stick surface by nature, but often adhesive bonds are also required to resist extreme temperatures and / or chemical exposure.  PTFE is often found in electrical components, high lubricity mechanical parts, non-stick cook wear and various things such as chemical handling equipment and tank liners. It also crops up in blended forms to add high temperature and chemical resistance to other types of plastic (and interferes with their bondability too unfortunately!).

Surface preparation and PTFE adhesive selection

Before the introduction of special primers such as Permabond POP or structural acrylics such as Permabond TA4610, fluorocarbon etchants were used to pre-treat the PTFE to allow adhesive bonding. These materials are becoming more difficult to get hold due to shipping hazards and many workplaces are trying to lower worker exposure.  Using an etchant allows great freedom of choice of industrial adhesive after treatment – this could be important if you have other performance considerations.

Permabond POP Primer and cyanoacrylate adhesive combination work well on PTFE. Brush the POP Primer onto the untreated PTFE surface before bonding with any of the Permabond cyanoacrylates. Permabond 105 is particularly good but if you require high temperature resistance then Permabond does offer cyanoacrylate which will go up to 250°C (482°F). There are limitations though – if you are bonding dissimilar surfaces, opt for a toughened grade such as Permabond 737 which will allow some flexibility to cope with differential expansion and contraction. Cyanoacrylate gap fill is limited to 0.5mm and they are unsuitable for spreading over large areas.

Permabond also offers TA4610 (and a range of similar products with varying cure speeds). This is a two-component 1:1 mix ratio structural acrylic which can be applied, without primer, to untreated PTFE surfaces and achieve a reasonable bond strength on this non-stick nasty!

Plasma, corona, flame or surface roughening by abrasion don’t provide significant improvements in bond strength to PTFE unfortunately .  For further assistance, please contact the Permabond technical helpline, despite the bonding nature of PTFE we would still be very happy to receive your call!